For home theaters with Blu-ray

1. Disconnect the power cord and the speaker cables from the wireless receiver for one minute and place the wireless receiver near to the home theater.
2. Switch off the home theater and then switch it back on again.
3. Switch the home theater to either AUX source or MP3 link source.
4. Connect the power cord for the wireless receiver.
   • The indicator on the wireless receiver blinks.
5. Press and hold the Navigation button,  (right) until 'PAIRING' blinks on the home theater display panel.
   • 'PAIRED' is displayed.
6. Connect the speaker cables to the wireless receiver.
   • The wireless receiver is ready to use again.
7. If 'FAILED' is displayed, repeat steps 1 to 6.

For other home theaters

1. Disconnect the power cord from the wireless receiver for a few seconds and then reconnect it. 
2. Press .
3. Press INFO .
   » A screen is displayed.
4. Press 1 , then press SURR within 5 seconds and check the set display.
   » ' PAIRING SUCCESS' is displayed.
5. If 'PAIRING FAIL' is displayed, repeat steps 1 to 4.