Before you begin, make sure both speakers are already paired with your Bluetooth device (such as a Bluetooth-enabled mobile phone).
- The speakers shown on the Bluetooth menu of the Bluetooth device should be indicated either as “connected” or “not connected” instead of “Not Paired” if the speakers are already paired with the Bluetooth device.

Follow the steps below to pair the two speakers:

1. Switch on both speakers.
2. Make sure the Smart Sensor of both speakers are switched on. If not, press the button indicated on the diagram twice to switch it on.
   Tip: check whether the Smart Sensor is switched on by swiping over it. It is on if there is an audio feedback when you swipe over it.
    
3. On your Bluetooth device, switch off the Bluetooth feature.
   Pair the two speakers using EITHER method (A) or (B) below.
   Note: Method (A) (ie, one-hand operation) is recommended because it is slightly easier.
   
   Method (A): One-hand operation:
   
   (i) Place the two speakers horizontally, as close as possible to each other, as shown in the diagram.
   Important: Make sure you place the speakers so that the Smart Sensor on one speaker is on the right-hand side; and the Smart Sensor is on the other speaker is on the left-hand side.
   
   
   
   
   (ii) Swipe you hand over the Smart Sensors from left to right, as indicated by the arrow.
   Note: Make sure your hand is swiped immediately above the Smart Sensor (within 4cm above the Smart Sensors).
   
   If the Smart Sensors successfully detect the motion, a tone would be given from each speaker. If there is no tone given, reset both speakers, pair them with your Bluetooth device and repeat from step 1.
   
   
   (iii) The two speakers would start pairing automatically. This would take a short while (approximately half a minute).
   
   (iv) When the message “Left Speaker” and “Right Speaker” given from the speakers respectively, the pairing is successful.
   
   (v) On your Bluetooth device, switch on the Bluetooth feature.
   
   (vi) Connect the Bluetooth device to the left speaker (ie, the speaker placed on your left-hand side).
   
   (vii) Play music from the Bluetooth device.
   
   Method (B): Two-hand operation:
   
   (i) Place the two speakers horizontally as shown in the diagram.
   Important: Make sure you place the speakers so that the Smart Sensors are on the same side of the speaker.
   
   
   
   
   
   
   (ii) Swipe your two hands over the Smart Sensors as indicated by the arrows in the diagram. (Swipe your left hand from left to right; and swipe your right hand from right to left)
   Note: Make sure your hand is swiped immediately above the Smart Sensor (within 4cm above the Smart Sensors).
   
   If the Smart Sensors successfully detect the motion, a double tone would be given from each speaker. If there is no audio signal, reset both speakers, pair them with your Bluetooth device and repeat from step 1.
   
   
   (viii) The two speakers would start pairing automatically. This would take a short while (approximately half a minute).
   
   (ix) When the message “Left Speaker” and “Right Speaker” given from the speakers respectively, the pairing is successful.
   
   (x) On your Bluetooth device, switch on the Bluetooth feature.
   
   (xi) Connect the Bluetooth device to the left speaker (ie, the speaker placed on your left-hand side)
   
   (xii) Play music from the Bluetooth device.

If you need to adjust the volume of the paired speakers, use the left speaker as the master one.

Note:

• The two paired speakers can be placed apart with a maximum distance of 5 meters in-between. For optimal performance, do not place any object between the speakers

• Once any of the speakers is switched off, or out of range, their paired status is lost.