How to program channels when using cable as the signal source.


Note: Check if a cable box is used to tune the channels. If yes, you will need to set the TV to the output channel of the cable box and use cable box to change channels. You will not need to program channels.

  1. Press the 'MENU' button, then press the cursor up/down to select INSTALL and press cursor right.
  2. Press the cursor up/down to select TUNER MODE, press the cursor right and press cursor left/right to select CABLE.
  3. Press the cursor left, press cursor up/down to select AUTO PROGRAM and press cursor right to start the auto programming.
    Note: Please wait as automatic installation will take sometime.
  4. Once auto programming is completed, it will return to the INSTALL menu.
  5. Press the 'STATUS/EXIT' button to exit the menu.

Was this document helpful?

Yes No Need to try first

Give us your feedback on this FAQ. What could we have done to to answer your question better?