Why can't I learn correctly with my ProntoNEO?


If you can't learn some codes with your ProntoNEO, check that the following requirements are fulfilled:
  • Be sure that batteries are correctly charged in both source remote control and ProntoNEO.
  • The learning distance between remote controls should be approximately 2.5 cm (0.98 in.). They should form an angle of +/- 40 degrees.
  • Try to avoid any source of interference that may disturb the learning phase (non reflective surface, fairly low light ambient).

Was this document helpful?

Yes No Need to try first

Give us your feedback on this FAQ. What could we have done to to answer your question better?