Question

Connecting to a TV that has Component Video In Jacks.

Answer

  1. Connect your Antenna or Cable TV signal to the ANTENNA jack on the rear of the DVD Recorder.
  2. Connect the DVD Recorder’s COMPONENT VIDEO OUT Y PB PR jacks (EXT 3) to the corresponding COMPONENT VIDEO IN jacks on the TV. Use the supplied three-strand component video cable, which has ends with red, blue, and green stripes. Match the cable stripe colors to the jack colors.
  3. Connect the DVD Recorder’s red and white AUDIO OUT (Left and Right) (EXT 3) jacks to the left/right AUDIO IN jacks on the TV. Use one of the supplied two-strand audio cables, which has ends with red and white stripes. Match the cable stripe colors to the jack colors.
  4. Connect the supplied power cord to the MAINS (AC Power) jack on the rear of the DVD Recorder. Connect the power cords of the DVD Recorder and the TV to a power outlet.
  5. Press the STANDBY-ON button on the front of the DVD Recorder to turn on the DVD Recorder. The STANDBY-ON light will turn green. If “TURN ON TV” appears on the display panel, you need to turn on your TV and set it to the correct Component Video In input/channel.
  6. Turn on the TV power. Set the TV to the correct Component Video In input/channel. This is not channel 3 or 4 as it might be when using a VCR.

Was this document helpful?

Yes No Need to try first

Give us your feedback on this FAQ. What could we have done to to answer your question better?