How to configure Control Panel and Extenders in multiple subnets?


  • On most routers, Multicast discovery works well within the same subnet but not across subnets. This might result in extenders not being found over different subnets.
  • Set-up the Control Panels and Extenders preferably in the same subnet.
  • If, due to network topology, the control panels and extenders must reside in distinct subnets; configure control panel and extenders with fixed IP addresses and specify them as such in the editor. Always make sure not to have conflicting IP addresses on the network.

Was this document helpful?

Yes No Need to try first

Give us your feedback on this FAQ. What could we have done to to answer your question better?