Question

Why are my codes not learned properly?

Answer

Please check whether the original remote you wish to learn to the control panel is performing correctly and that the batteries are fully loaded.
Put the remote you want to learn flat on the table, the sending eye pointed towards the learning eye (located on the left bottom side of the TSU9600 and top left side of the TSU9400). Press for about 1 second the button you want to learn. If the codes still have dificulties learning, try the 'raw learn' mode.
Try to avoid Infra Red light disturbance by other IR light sources such as sun light, fluorecent lights, dimmed halogens, mobile phones/laptops equiped with an irda port, ...
 

Was this document helpful?

Yes No Need to try first

Give us your feedback on this FAQ. What could we have done to to answer your question better?