Question

The installation wizard on the CD doesn't work, can I install the Wireless Base Station manually?

Answer

Yes, follow the steps below.

Step 1: Make sure your network adapter is set to receive an IP address automatically
Click Start => Control Panel
double click on Network Connections 

Right-mouse click the Ethernet port that is connected to the Wireless Base Station
Click on Properties 



Select Internet Protocol (TCP/IP) [1] and click on Properties [2]



Checkmark Obtain an IP address automatically 


Click OK an click OK in the 'Ethernet port Properties' window



Step 2: Determine the IP address of your Wireless Base Station
Click Start => Run


Type cmd and click OK


In the Dos window type ipconfig followed by Enter


The Default Gateway shows the IP address of the Wireless Base Station (192.168.1.2 in this example)

Step 3: Browse to your Wireless Base Station
Open Internet Explorer and type the Default Gateway address (192.168.1.2 in this example) in the Address bar


 Click Go


You should now see the setup page

If this is not the case :
Make sure that the cables are connected correctly at the PC side and the Wireless Base Station side (Lan1 port)
Perform step 1 for all network adapters
In the Dos window type ipconfig /renew and wait a minute or so. Windows should now have received an IP address from the Wireless Base Station.

Was this document helpful?

Yes No Need to try first

Give us your feedback on this FAQ. What could we have done to to answer your question better?