How can I set the clock on my system?


There are two methods for setting the clock:

  • Automatic clock setting
  • Manual clock setting

Automatic clock setting

  1. Tune to a RDS station.
    • When you receive a RDS station, the symbol and the station name will be displayed.
  2. Press and hold RDS button for more than 2 seconds.
    • The system will automatically store the time signal transmitted from the RDS station.

Note: The accuracy of the time depends on the RDS radio station.

What is RDS?

Radio Data System (RDS) is a service that allows FM stations to show information such as the station name.

Some RDS radio station transmits a real clock time at an interval of every minute. It is possible to set the clock by using a time signal which is broadcast together with the RDS signal.

Manual clock setting

The clock can be set in either a 12-hour or 24-hour mode.

  1. In standby mode, press and hold CLOCK on the remote control.
    • SET CLOCK is displayed briefly. The clock digits for the hours begin to flash.
  2. Press on the remote control to select clock mode.
    • "12 TO 24 HOUR” or “24 TO 12 HOUR” scrolls once on the display. Then the clock digits for the hours continue to flash.
  3. Press VOLUME -/+ (or press VOL -/+ on the remote control) to set the hours.
  4. Press CLOCK again.
    • The clock digits for the minutes flash.
  5. Press VOLUME -/+ (or press VOL -/+ on the remote control) to set the minutes.
  6. Press CLOCK to confirm the settings.

Was this document helpful?

Yes No Need to try first

Give us your feedback on this FAQ. What could we have done to to answer your question better?