Question

How to setup channels (Auto Channel Presets)

Answer

  1. Press [SETUP] on your remote control. If you see the following screen:

    Proceed to STEP 2              Proceed to STEP 3


  2. Use [ / ] to select “General Setting”, then press [OK].
  3. Use [ / ] to select "Channel", then press [OK].
  4. Use [ / ] to select "Auto Channel Preset", then press [OK].
  5. Use [ / ] to select the type of broadcasting signal, then press [OK]
    • Antenna (When using antenna):
      • The channels broadcasted in analog TV and digital TV are automatically scanned and memorized. Only the receivable channels in the area will be memorized.
    • Cable (Analog) when using basic cable:
      • The channels broadcasted in analog CATV are automatically scanned and memorized.
    • Cable (Analog / Digital) when using basic cable:
      • The channels broadcasted in analog CATV and digital CATV are automatically scanned and memorized.

*Note: To cancel the auto channel preset during scanning, press [BACK] or [SETUP] to cancel.

Was this document helpful?

Yes No Need to try first

Give us your feedback on this FAQ. What could we have done to to answer your question better?