In order to enjoy the highest picture quality available, make sure that your setup complies with the following conditions:

• Connect the signal source by means of a HDMI cable.
• Verify that the source signal is of High Definition (HD) content, which means either the 1080i or the 1080p video format.
   
  Note: If your external device does not have HDMI outputs, the next best option is the YPbPr- (or component-, or YUV-) connection.

You will only be able to enjoy the full advantages of High Definition content if you connect your external device by means of a HDMI cable.

Although an analog connection does not offer the same quality, you can still obtain an excellent picture if you observe the following guidelines:

1. Check your cables and cable-connections.
    
   1. Make all your cables as short as possible.
   2. Use high quality antenna cable.
   3. Connect the plugs well into their sockets.
   4. Do not use an antenna cable splitter. Splitting the signal will make it considerably weaker.
       
2. Change the picture settings on your TV. The standard configuration is set to match the conditions in a TV shop.
   
   You can use the 'AUTO MODE' button on the remote control to set your TV to a predefined picture mode that will give you the best picture quality.
    
   Alternatively, follow these steps to select the settings that suit to your preferences:
    
   1. Press the 'MENU' button on the remote control to display the main menu.
   2. Select TV SETTINGS and press the cursor right to display the TV settings menu.
   3. Press the cursor down to select PICTURE and press the cursor right to display the picture menu.
   4. Press the cursor up/down to access the PICTURE settings.
   5. Press the cursor right to select and the cursor up/down to adjust them according to your preferences.
   6. Press the 'MENU' button to exit the menu.
       
3. Switch on the ACTIVE CONTROL on your TV.
    
   With Active Control the TV continuously measures and corrects all incoming signals to maximize the picture quality.
    
   1. Press the 'MENU' button on the remote control to display the main menu.
   2. Select TV SETTINGS and press the cursor right to display the TV settings menu.
   3. Press the cursor down to select PICTURE and press the cursor right to display the picture menu.
   4. Press the cursor up/down to select ACTIVE CONTROL and press the cursor right.
   5. Select ON WITH LIGHT SENSOR and press the 'OK' button to confirm your selection.
   6. Press the 'MENU' button to exit the menu.

 HDMI cable

 YPrPb cable