My shaver does not cut long hairs. What can I do?


Longer hairs (> 1mm) have to be cut with the integrated pre-trimmer first. Therefore make sure that the trimmer touches the skin by canting the applicance a little bit forward and/or backward.

  • Move the appliance against the direction of hair growth.
  • In case that cut hairs have accumulated below the trimmer, remove them.
  • After the long hairs have been cut remove the stubbles with the foil (the foil should have full contact with the skin).

Attention: the pre- trimmer shortens the hair to a lenght of 0,5-1mm, then the foils shaves the hair smoothly.


Was this document helpful?

Yes No Need to try first

Give us your feedback on this FAQ. What could we have done to answer your question better?