How do I remove the shaving heads and then put them back?


Make sure the appliance is switched off.

Press the release button and open the shaving unit.


Pull the shaving head holder off the bottom part of the shaving unit.



Turn the retaining rings counterclockwise and remove them.


Remove the shaving heads from the shaving head holder. Each shaving head consists of a cutter and guard.

Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally put a cutter in the wrong shaving guard, it may take several weeks before optimal shaving performance is restored.


Clean the cutter and guard under the faucet.


After cleaning, place the cutter back into the guard.



Put the shaving heads back into the shaving head holder.


Note: Make sure the projections of the shaving heads fit exactly into the recesses of the shaving head holder.



Place the retaining rings back onto the shaving head holder and turn them clockwise.


Each retaining ring has two recesses and two projections that fit exactly into the projections and recesses of the shaving head holder.


Turn the ring clockwise until your hear a ‘click’ and the ring is fixed.


Note: Hold the shaving head holder in your hand when you reinsert the shaving heads and reattach the retaining rings. Do not place the shaving head holder on a surface when you do this, as this may cause damage.


Reinsert the hinge of the shaving head holder into the slot of the shaving unit. Close the shaving head holder (‘click’).

Was this document helpful?

Yes No Need to try first

Give us your feedback on this FAQ. What could we have done to to answer your question better?